Tile Table Layout doesn't work

[BupNup]

Hello,

I've set the size of the window that I want it to open, but when the tables start opening it won't arrange none, neither the hotkey works.
But the cascade, stack and the other layouts are working fine.

Hope anyone can help me.

Thank you.

[BupNup]

More info, when I open a table it just says: "[02:56:14.19] You have too many tables We can not tile Them.."

Thank you

[sideshow]

Hi,

How many monitors are you using?

If you use one specific monitor for tables then go to layout > edit > in the monitor section at the top disable the monitor not in use by poker tables, then click tile and edit and place the display table where you want it to appear. Save and close let me know if this helps.

[BupNup]

Hello Sideshow,

Yes it worked thank you very much :)
But if I want to used my second monitor and use it as "Table aside"?
Is it possible?

Because whenever I enable my second monitor the Tile Layout stops working.

Thank you once again.

[sideshow]

Hi,

Yes you can leave it disabled in the Monitor section, but when you go to setup the set aside tables you can still put them on the second monitor with out it being enabled.

[BupNup]

I tried "table aside" and it worked as you said :)

But, there is no way to make the tables extend through my second monitor?

Thank you

[sideshow]

Hi.

I am not sure what you mean, you want the set table aside on the second monitor? If so Just put the display window when you edit table aside onto the second monitor.

[BupNup]

No, the question was related to the tile layout not the table aside.
Is it possible to have my second monitor enabled so the tiled tables expand?
Because when I enable the second monitor the Tile Layout stops working.

I hope I have been clear :rolleyes:

Thank you

[sideshow]

Hi,

Yes if you enabled the second monitor, then click on tile > edit > place the display window in the top left of the first monitor or the second its up to you. Click save and close the open tables and once you can't fit tables on once monitor they will go to the next.

[Zagg94]

Hello. I did that you said but tile doesnt work. i use one loptop. what to do?

[Sarek]

Please show 2-monitor screens:
a) Table control - layout - edit (with all information visible + "initial" Tile slot where you put it)
b) Tile layout applied when play (2 or 3 tables)

But please consider: Tables can be tiled IF they fit in Tile - both in monitor height and width
See examples
http://imageshack.com/a/img593/9585/odzk.gif

http://imageshack.com/a/img822/2664/2kif.gif

[kally]

Hello,

for me the tile layout isn't working too.
Here the two screenshots:

159982159983

Do you have an advice for me?

Thank you very much in advance!

Greets

[Ninja Support]

Hi,

This is because Tile layout must start in the top left corner of your screen, from what i see you have it in the top right, also if you have table aside slots there it will not work, I would suggest you move the table side slots to your second monitor and use the main monitor for you tile layout.

[kally]

Thanks, now it works :)

[Ninja Support]

Hi,

Thank you for letting us know the issue is resolved, If you need assistance with anything else please let us know.

Have a nice day and best of luck at the tables.