View Full Version : How do I stop TN2 from moving my FTP tables around?
Setcho
12-01-2013, 05:28 PM
Hi,
When I have a few tables up and open a new FTP table TN2 will move all my tables around. Anyway to stop this from happening?
/S
sideshow
12-01-2013, 06:08 PM
Hi,
Are you using a layout in TN2? What do you mean by moving them around?
Setcho
12-01-2013, 06:29 PM
I haven't chosen any layout as far as I know. Moving around = My tables are in spot A, I open a new table and all 3 tables jump somewhere else.
sideshow
12-01-2013, 08:35 PM
Hi,
They shouldn't be Jumping, if you go to the hot keys tab > table control > layout
If you use no layout and want the tables to go where you want them then choose Layout = None
If you have hot keys setup for Table layout i would remove these, because if you click any of them hot keys it will assign all tables to that layout.
If you use two monitors but only use one for Poker then in the layout tab click on edit > In the monitors section untick the monitor which you do not use.
If none of this helps then please email us your TN2 log file and we can see what is causing this issue. To do this go to the setup tab > send logs to table ninja and email the zipped file to support@tableninja.com with a breif description of the issue or a link to this thread.
Setcho
12-02-2013, 03:25 AM
Thanks, the hot keys tab > table control > layout did the job.
sideshow
12-02-2013, 07:17 AM
Hi,
Thank you for informing us that the problem was resolved, If there is anything else we can assist you with please let us know.
Have a nice day and best of luck at the tables.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.