Medici
10-14-2010, 04:33 PM
Hi there
I've recently found that the edges fonts on my HUD sorta "break" if the table scanner is scanning when the HUD was refreshed, otherwise it is OK. It also happens only if I set the font size to 6 - didnt try 5 cos it's too small, anything 7 and bigger wont be affected it seems.
Ive tried different fonts, bold/normal. Same thing happens. The attached picture shows the difference, they are both Verdana bold size 6. I am running version 1.11.05, on windows XP
It may seem a bit nit picking but the smaller fonts would allow me to put a lot more numbers there and the broken numbers are sometimes misread.
I'd appreciate any idea on this.
Thanks
I've recently found that the edges fonts on my HUD sorta "break" if the table scanner is scanning when the HUD was refreshed, otherwise it is OK. It also happens only if I set the font size to 6 - didnt try 5 cos it's too small, anything 7 and bigger wont be affected it seems.
Ive tried different fonts, bold/normal. Same thing happens. The attached picture shows the difference, they are both Verdana bold size 6. I am running version 1.11.05, on windows XP
It may seem a bit nit picking but the smaller fonts would allow me to put a lot more numbers there and the broken numbers are sometimes misread.
I'd appreciate any idea on this.
Thanks