PDA

View Full Version : HEM not launching after initial setup



vanizzle
04-11-2010, 08:53 PM
Hello!

I had just purchased HEM to install on my WinXP computer. It meets all the requirements and what not. My issue is that when I install it along with Postgre an error comes up and says "Test Firewall has crashed... send error report... yadda yadda". I click don't send, it finishes installing HEM along with postgre. When I try to start HEM after the installation mouse with the hourglass comes up for a few seconds... then NOTHING!

I disabled my firewall, did the start service/stop service thing and nothing! I need some help! I don't want to ask for a refund because it's not working on my computer.

Any response would be appreciated.

-vanizzle

morny
04-11-2010, 10:16 PM
If that installer fails to install PostgreSQL, please reinstall PostgreSQL using the following instructions:
A) Start > Programs > Accessories > Command Prompt > Right-Click > Run As Administrator

net user postgres /delete
B) Reboot.
C) Try installing this version of PostgreSQL - http://www.holdemmanager.com/downloads/Postgres_8.3.9-v1.0.7.exe

vanizzle
04-11-2010, 11:35 PM
I just did this and it still doesn't work, mouse comes up with an hourglass like its going to load but it just sits there. :/

netsrak
04-12-2010, 03:19 AM
Please make sure that your Windows is uptodate (Windows Update, Service Pack level)
Also make sure that Microsoft .net Framework 3.5 service pack 1 is installed.

Uninstall your firewall solution completely, reboot your computer and try again.

If its still not working please schedule a remote support session with our support. Email support@holdemmanager.net, with a link to this thread and your forum name, so we can setup a Teamviewer (http://www.holdemmanager.net/teamviewer) session.

vanizzle
04-12-2010, 03:33 PM
IT WORKED!!!!!!!!!!

thanks!